Combine the power of two Blueprints for a sophisticated information solution

Adding a Live Blueprint inside of a Page Blueprint can be a smart way to isolate and manage certain content sections that may change over time. Doing so means you get the standardization of a template in a Page Blueprint combined with the dynamism of a Live Blueprint. 

One specific application may be on a team page. These are often standardized and so benefit from a Page Blueprint. But there may be certain sections of the Team Template, such as a common set of Department Resources, that you'd like to manage separately. This How-To Article describes how you might go about creating this.

Use h4 for section headings

If you don't want numbers in the section headings, simply remove the "numbered" class from this block.

Note/Tip/Warning/Info blocks below are collapsed by default. If you want to use any of these, try to keep to just one per page. You may use two if necessary, but in general, try to limit these.

If using:

  1. Replace me with something to note about this how-to entry that falls outside the scope of all other sections; and
  2. Add the tight-bottom class to the Steps block above to narrow the gap between the two blocks.

If using:

  1. Replace me with something to note about this how-to entry that falls outside the scope of all other sections; and
  2. Add the tight-bottom class to the next visible/non-collapsed block above this one to narrow the gap between the two blocks.

If using:

  1. Replace me with something to note about this how-to entry that falls outside the scope of all other sections; and
  2. Add the tight-bottom class to the next visible/non-collapsed block above this one to narrow the gap between the two blocks.

If using:

  1. Replace me with something to note about this how-to entry that falls outside the scope of all other sections; and
  2. Add the tight-bottom class to the next visible/non-collapsed block above this one to narrow the gap between the two blocks.