Display a sequence of Search Filter options selected from a picklist in a Blueprint.

When using Targeted Search and Blueprint Maker to connect a Search Filter Group to a Blueprint picklist, there are additional display options to consider for display. These include displaying the human readable name (instead of the label) and also displaying multi-selections in a sequence. The steps and information below describe how to prepare your Blueprint for your preferred display.

Use h4 for section headings

If you don't want numbers in the section headings, simply remove the "numbered" class from this block.

Note/Tip/Warning/Info blocks below are collapsed by default. If you want to use any of these, try to keep to just one per page. You may use two if necessary, but in general, try to limit these.

If using:

  1. Replace me with something to note about this how-to entry that falls outside the scope of all other sections; and
  2. Add the tight-bottom class to the Steps block above to narrow the gap between the two blocks.

If using:

  1. Replace me with something to note about this how-to entry that falls outside the scope of all other sections; and
  2. Add the tight-bottom class to the next visible/non-collapsed block above this one to narrow the gap between the two blocks.

If using:

  1. Replace me with something to note about this how-to entry that falls outside the scope of all other sections; and
  2. Add the tight-bottom class to the next visible/non-collapsed block above this one to narrow the gap between the two blocks.

If using:

  1. Replace me with something to note about this how-to entry that falls outside the scope of all other sections; and
  2. Add the tight-bottom class to the next visible/non-collapsed block above this one to narrow the gap between the two blocks.