Let users choose from a fixed set of values when creating a page or space from a Blueprint. 

In addition to user-entered text and file attachments, you can now use a picklist of options inside the Blueprint Wizard. This is a great way to further control the output of a blueprint, and provide greater ease-of-use to your content creators. This guide describes how to set up  picklist of options.

Use h4 for section headings

If you don't want numbers in the section headings, simply remove the "numbered" class from this block.

Note/Tip/Warning/Info blocks below are collapsed by default. If you want to use any of these, try to keep to just one per page. You may use two if necessary, but in general, try to limit these.

If using:

  1. Replace me with something to note about this how-to entry that falls outside the scope of all other sections; and
  2. Add the tight-bottom class to the Steps block above to narrow the gap between the two blocks.

If using:

  1. Replace me with something to note about this how-to entry that falls outside the scope of all other sections; and
  2. Add the tight-bottom class to the next visible/non-collapsed block above this one to narrow the gap between the two blocks.

If using:

  1. Replace me with something to note about this how-to entry that falls outside the scope of all other sections; and
  2. Add the tight-bottom class to the next visible/non-collapsed block above this one to narrow the gap between the two blocks.

If using:

  1. Replace me with something to note about this how-to entry that falls outside the scope of all other sections; and
  2. Add the tight-bottom class to the next visible/non-collapsed block above this one to narrow the gap between the two blocks.