Create the existing page over again based on its original Blueprint.

Use the "Regenerate This Page" option in the Brikit Blueprints Menu to create a new page from the source Blueprint. You will be prompted to re-enter any substitution field values. On close of the Blueprint wizard, you will have a new page, populated with your substitution field values. 

Note that any existing content on the page will be overwritten by this process.

Use h4 for section headings

If you don't want numbers in the section headings, simply remove the "numbered" class from this block.

Note/Tip/Warning/Info blocks below are collapsed by default. If you want to use any of these, try to keep to just one per page. You may use two if necessary, but in general, try to limit these.

If using:

  1. Replace me with something to note about this how-to entry that falls outside the scope of all other sections; and
  2. Add the tight-bottom class to the Steps block above to narrow the gap between the two blocks.

If using:

  1. Replace me with something to note about this how-to entry that falls outside the scope of all other sections; and
  2. Add the tight-bottom class to the next visible/non-collapsed block above this one to narrow the gap between the two blocks.

If using:

  1. Replace me with something to note about this how-to entry that falls outside the scope of all other sections; and
  2. Add the tight-bottom class to the next visible/non-collapsed block above this one to narrow the gap between the two blocks.

If using:

  1. Replace me with something to note about this how-to entry that falls outside the scope of all other sections; and
  2. Add the tight-bottom class to the next visible/non-collapsed block above this one to narrow the gap between the two blocks.