Create the existing page over again based on its original Blueprint.

Use the "Regenerate This Page" option in the Brikit Blueprints Menu to create a new page from the source Blueprint. You will be prompted to re-enter any substitution field values. On close of the Blueprint wizard, you will have a new page, populated with your substitution field values. 

Note that any existing content on the page will be overwritten by this process.

Open the Brikit Blueprints Menu

It is located in the Confluence Header. Check out Accessing the Brikit Blueprints Menu for detailed instructions.

Click 'Regenerate This Page'

Don't see it? That's because the page you are on was not originally generated from a Blueprint. This option is only available to pages created from Blueprints.

Clicking this option takes you through the 'Blueprint Wizard' process, a set of windows with options for entering data needed to generate the page.

Enter in any substitution field values

If there were substitution fields used in the source page Blueprint, then you will be prompted to enter them here.

Change the page title (optional)

Click 'Submit'

This will 'update' the existing page by regenerating it from the source page Blueprint based on your substitution field values.

That's it!

If using:

  1. Replace me with something to note about this how-to entry that falls outside the scope of all other sections; and
  2. Add the tight-bottom class to the Steps block above to narrow the gap between the two blocks.

If using:

  1. Replace me with something to note about this how-to entry that falls outside the scope of all other sections; and
  2. Add the tight-bottom class to the next visible/non-collapsed block above this one to narrow the gap between the two blocks.

If using:

  1. Replace me with something to note about this how-to entry that falls outside the scope of all other sections; and
  2. Add the tight-bottom class to the next visible/non-collapsed block above this one to narrow the gap between the two blocks.

If using:

  1. Replace me with something to note about this how-to entry that falls outside the scope of all other sections; and
  2. Add the tight-bottom class to the next visible/non-collapsed block above this one to narrow the gap between the two blocks.